Counting matching models…
This is a contraption to assist in feeding solder when making multiple joints. It lets more solder be advanced with minimal movement or effort to reposition. A 3d printed hollow tube forms the base and with a wire ferrule connection at…
An adapter to directly connect a Worx WA4054.2 LeafPro collection hose to a Ryobi Vac Attack mulching leaf vacuum. The vac attack needs to be modified by cutting off the curved part of the discharge chute as shown, roughly 2 inches from…
This connector back shell fits around the guts from from a DB-9 female solder cup to create an Atari style joystick plug. The fit up is pretty fiddly, will need to scale or adjust sizes to match. Crimp style DB-9 connectors I tested were…
Storage cap to keep insects & debris from pressure washer during storage. M22x1.5 threads.
This Reolink camera has threaded 1/4 -20 holes on top and bottom. This plug was designed to keep water and debris out of the unused hole on top of the camera. 6x2 or 6.8x1.9 mm o-rings from assortment kit will work.
The wire guide recessed area interferes with the carriage flag for optical encoder upgrades. Remixed to offset recessed area to side to avoid interference. Category: 3D Printer Accessories
I didn't have luck getting belt tension set consistently with other methods or belt tension designs. I designed this model using a cheap test indicator to measure the flex on the belt. The contact points are glued in place to make it…
Camera mount that fits in the tower channel below the belt tensioner. Gets it out of the way and provides a lower view of the entire bed and doesn't get obscured like the stock camera. Needs two M2.5x16 screws and optional 10mm x 2mm…
These tools were designed to aid in installing boundary wire using when using a lawn edger to cut a trench. The hooked tool is used to clean out any debris or grass left in the trench. The rounded tool is used to force the wire into the…
This mount replaces the stock spool holder. The factory M3x6 screws can be used for the mount. The BTT needs some M3x10 screws. The screws in BTT kit are too short. Sensor is aligned with the hole in top of printer to feed filament from…
Remixed base to fit on Monoprice mini delta bed Ø110mm. Category: Tools
This is a 2 piece case for the SparkFun MicroMod Input and Display Carrier Board . The case was printed with PLA. The joystick and button operators are a bit small and were printed on resin printer. The two halves of the case sandwich the…
Holder for cheap PTZ joysticks from ebay / amazon.
My take on the binder clip bed retainer and tower shield for MPMD. M2.5 heat set inserts installed in the 2b part then gets installed under the platform. Tight fit to get between motor and the plate but it fits. M3 heat set insert for the…
A rigid mount for BTT smart filament sensor to titan extruder clone. After printing use M10x1 die to cut threads. Install PTFE tube completely into sensor then trim to length based on extruder. Mine was about 17mm. Category: 3D Printer…
These are all currently available results.
