Counting matching models…
The model is a system of stackable boxes designed to hold and organize lock picks and tensioners. Magnets are used to retain the contents and to hold together the boxes and lids. The size of the boxes was determined by my requirement to…
A shelf holder pin for the Ikea billy shelf for adding non-original boards (i.e. without the hole for the notch). It uses a thin flap between the side and the board to increase the stability (without, it would just bend inwards). I…
This model is meant for lock sport purposes. Do not use it on a lock in use as it reduces the security provided by the lock. A piece designed to replace the original backplate of S&G 6700 Series safe locks. It is open allowing inspection…
Elements with 2 or 3 hooks mountable to Billy shelves without screws or any tools. Usable for hanging jackets. it uses the slight overhang of the side pieces on the top for stability. The design has sufficient space for two sided tape for…
This is a case I created for the logic analyzer designed by gusmanb on github. ( https://github.com/gusmanb/logicanalyzer ). I use the version 6.0 PCB ordered from PCBWay. I extended it to be battery powered using a lipo cell. I used the…
A replacement for the original plastic cover next to the seat of tractors of the Fiatagri 94 series. Originally created for the Fiatagri 88-94. Should fit for at least all tractors of the series. The part is symmetric and fits both sides.…
A small and simple holder to hang an Omnifixo board on a Skadis board. A very simple model but it does not look bulky. I printed it in PETG, but PLA should work fine, too. Of course, you have to print the part twice to hold the board.…
These are all currently available results.
