11 models
The body cap has a slightly undersized M42x1 thread and the rear lens cap has a sightly oversized M42x1 thread. This ensures a loose fit. The prints shown in the pictures were done with a layer height of 0,15mm.
This holder/adapter is designed to provide a secure and versatile way to mount your DJI Mic 2 to a wide range of action cam accessories, including the DJI selfie stick. The model can be printed as oriented for best stability. Supports…
I have sliced the model in cura and added supports below the notches. Variant 2 has serrations on the sides that were intended to make it a grippy surface to aid removing the cover. But pressing on the side also jams the cover to the…
Replacement wedge for the Manfrotto Super Clamp
These lens boards fit a Linhof Kardan Standard monorail 4"x5" camera Lens board for a Copal #0 shutter (34,6mm - hole diameter is 0,2mm oversize) Lens board for a Copal #1 shutter (41,6mm - hole diameter is 0,2mm oversize) Lens board for…
Adapter to mount more or less any camera with interchangeable lenses to a Lomo microscope. All that's needed besides this adapter are extension tubes and an M42 to your camera mount adapter. These can be found plenty for little money on…
If the cover is a bit hard to take off the battery you may want to smooth the retaining nib by flame smoothing the surface of it. This can be done with a lighter flame or a soldering iron. Also sanding it smooth should work. All it takes…
Print this four times and attach them to your MULIG drying racks legs with super glue to prevent scatching your floor. I recommend printing with 100% infill to get maximum wear resistance Just to be sure ( in case Ikea has changed the…
Protective cover/shell for the Raspberry Pi HQ Camera module. Can be used with M2.5mm heat set threaded inserts or just clipped onto the PCB.
This is a threaded mount for the Lomo RF-5 450mm f10 enlarging lens. The lens has an M72x1 thread but it's often sold without the mount. I've added a simple cup-like lens cap that fits both front and back of the lens (68mm dia.). Test…
This adapter enables mounting M42 photo lenses to a Basler Racer camera. The M42 thread is already integrated into the model, so no additional steps are required for use. The adapter length is designed to maintain infinity focus (45.46 mm…
These are all currently available results.
