Counting matching models…
Large Van Norman index plates 4 plates total. 6 inch diameter plates with 1.5 id. Used for 10 inch american made dividing head not the more common 7.5 inch. English (inch) measurements - you may need to scale 2540% for software slicer to…
These pieces are for making molds to repair broken ceramic (porcelain) insulators in the ballast resistor of an obsolete Hobart welder-generator. I used these on my G-213 but they likely fit other models. Original design used 9 pieces, my…
My Globetrotter camper has white matte finish doors without handles to prevent wear, fingerprints etc. So I made up a set of these to use over stove and sink cabinet doors. My kitchen doors measure 7.45 mm thick so that's what I made.…
This is a basic plug to fit Storyteller running boards. These running boards are sold under many names such as Steelcraft and TAC. I recommend to print with strength setting - multiple shells, low infill etc. I usually do as a two color…
Here is a threaded cap with modified m68-6 threads to fit on the drain spout of a Dometic 970 series portable toilet. I sincerely doubt this will fit other portable toilets, etc. This setup allows for discreet use of your portable toilet…
Made these for my Tormach. The Grey machine base had covers either missing or left open to allow cords to pass through. So I made some covers with a 1 inch hole. Covers are a split design so that wires can be left intact to install. The…
These are all currently available results.
