Counting matching models…
This is a mag loader for the Grand Power Stribog 9mm, specifically the SP9A3 although I imagine it will work on the 9A3s and the 9A1 as well. It does not work with the newer Grand Power solid black mags with red followers. The feed lips…
Here's an insert to snap into the bottom of a Maglula Uplula loader to use with S&W Bodyguard 2.0 380 mags. This keeps the mag lined up in the loader while you're using it. I made this starting from the 1911 insert by…
This is a push down style speed loader for the ‘new’ (as of 2025) Global Ordinance USA made solid black mags for the 9mm Stribog. The feed lips on these mags have a different geometry than the older translucent mags with or without metal…
I needed to adjust the front sight on my S&W Bodyguard 2.0, but I don't have a sight pusher and I couldn't come up with a setup to drift the sight without the slide wanting to roll towards the sight. So I designed a block to support the…
This is a piston stop for zeroing a degree wheel on a chainsaw engine. It has M14x1.25 threads, the standard size for chainsaws using a BPMR7A plug or equivalent. To use it, you rotate the crank one way until the piston rests against the…
This is a fixture to hold a Wixey WR300 digital angle gage and mount it to an engine's crankshaft to measure port timing on a chainsaw motor. You zero the angle gage when the piston is at top dead center, then rotate the engine until…
This is a screen or filter that screws on the end of a garden hose. I made this to use with a Drummond drill powered pump to pump water out of a concrete block wall. Without the screen, the hose and pump were getting clogged with debris…
These are flip caps for the Swamp Fox Raider 1x prism sight. I don't like the rubber covers that come with the sight. They're slow to take off and snap to the battery cap. If you don't snap them to the battery cap, they flop around and…
These are all currently available results.
