Counting matching models…
I was asked to add a fan grill to the GMKtec Pro case by @RazziaDK. Because Noctua are so great, I went with their high efficiency grill fan, scaled down to fit 92mm fans.
This is a remix of an existing napkin holder in various sizes.
This model was made to create a jack with as small a footprint as possible in a drywall. I printed it as it is in the STL, leaning a bit more towards the back of it so the front looks as clean as possible. This one needs supports.
The connector needs to be printed parallel to the bed with a small raft. Assembly might require some force the first time, I suggest using glue to keep the parts together without wobbling in the long term.
I needed a riser for some of my Funko's, they're displayed in Ikea Billy bookcases. The idea was to fit as many as I could and have them fit as good as possible. Four of these can fit perfectly in a single door Ikea Billy bookcase. I also…
This is a simple leg replacement to use where the existing soft legs are. This was created to help with the airflow of the PC and allow for better intake at the bottom. The legs fit into the recessed area where the existing soft feet are,…
This is a stand for a wireless charger from UGREEN. According to the website, the model is "Qi2-MPP 15w wireless charging pad", it's 10 mm thick and 60 mm wide. The hole in the back is to make it easier to remove. Supports are needed, 25%…
This is a reupload from a thingiverse model. I've searched for a replacement nut for a bike reflector and after not finding much in Printables this one did the trick.
A closet separator for Ikea Pax closets (1.8 CM thick shelves) built in two pieces. The bottom part simply clips into the shelf and the actual separator clicks on it. it is pretty sturdy and does not come off, some of the prototypes I…
This is a simple cover for a pipe I needed to cover the drainage for plants.
These are all currently available results.
