Counting matching models…
NOTE: no need to print the wings V3 if you decide to print the V4 and viceversa, the same goes for the quest_stand, the only difference between the 2 is the text on the base. Update 03.07.24: New improved Controller wings and HMD model,…
Remixed quest 2 lens protecor. Print 2 of them and rotate (not in slicer) accordingly to each eye. The glasses spacer/lens protector is design to keep your glasses from rubbing on the lenses causing scratches on them. this is useful if…
Materials: Any is fine for the holder TPU for the anti slip base Instructions: Print the holder on its side to avoid overhangs and weak points Print the anti slip base twice in TPU to ensure it adds friction with your desk/table and glue…
I strongly recomend printing with PETG or any better heat resistant filament, as PLA might deform inside due to the high temperatures the inside of a computer can get while gaming or any high load task. Specifications: -No supports…
This model was inspired by the Xbox Stealth controller made by Yellowtech
Note 22.05.24: Added the stronger spring versions to also have the Slimmer Slider, but i have not printed or tested how much force or how easy it is to slide as there is less surface to push the OTF knife/comb open. This modification is…
The model is splitted into 2 parts so it can be printed in multiple colors with just one nozzle. Make sure to align it correctly so that the markings are flush with the ruler as is meant to fuze with it.
Follow the instructions of the original model for print settings, the only added hardware needed is a M4*10 screw that is screwed from the bottom to the top piece. dont tighten it too tight as this will increase the friction between base…
Update(06.07.25): New model for the BM_Mirror chanfering out sharp edges and adding locking tabs so that the mirror cannot spin once screwed into place. if the mirrors you bought dont have the holes on the gray plastic part like in the…
These caps allow you to better hold the inner ring to spin the ratchet without having to wear it. Designed in the model are arrows that tell you in which directon the ratchet spins (make sure to install it correctly). Make sure to print…
I made this model as i removed the filament sensor because it caused too much friction when printing tpu, since on retractions the filament would bend instead of going back through the sensor, it would falsely trigger, stopping the print.…
The model is only one leg, you need to duplicate and mirror in the slicer to get both as they're symetrical. The length stays the same so the angle range doesnt change from the original. IMPORTANT : the order of instalation matters. First…
These are all currently available results.
![Millimetric Ruler [20cm/200mm]](https://media.printables.com/media/prints/920207/images/7023447_3747fd4b-3ba8-49f4-83c2-4d83d4e5b86a_46bba639-7111-4824-8f92-bad1f096448f/ruler.jpeg)
