Counting matching models…
Thanks to Dany for the Gridfinity Blender File. I haven't got the hang of Fusion360 yet. I needed a name plate for work so I made this one. It is based on a 4x1 Gridfinity bin with magnets. I printed mine on the side and tuned off the top…
Gothic Kleenex Box Cover. Printed in PLA at 20% infill. I recommend not using supports, as they will probably be difficult to remove cleanly. This is designed to fit the square Tissue boxes that are about 5 inches square. I don't have a…
Skull with curly horns. You'll need supports!
This is a replacement for a 1979 Camaro Berlinetta glove box. the original is made out of cardboard and after several decades needed to be replaced. I had to split this into 2 parts for it to fit in my printer. This should print on a…
We removed the A/C from my wife's 1979 Camaro and wanted to replace the stock A/C vents with cubbies for storage. You will need the stock screws for the lower Vent Cubbies and 8 M3 screws and nuts for the front or upper cubbies. The two…
We updated my wife's car and found that the new front speaker would not fit in the original bracket. I made this to allow for the new speaker with a round magnet. Tips: I ran a zip tie through the dash bracket to further secure the…
The reservoir for my toothbrush cracked so I made this one. This fits snugly on the toothbrush, and does not have the original door for re-filling the water, so you'll have to twist it off to re-fill it. I printed this in PET-G with…
Plug to replace the rear window defroster switch on a 1979 Camaro Berlinetta. Ours was broken so I made this plug to cover where the original switch was. You will need the original clip to secure this to the dash. I've only tested this on…
Owl Klenex Box Cover, Printed in PLA, will need supports, I used organic supports for mine. Let me know how yours turned out!
These are all currently available results.
