Counting matching models…
This is a replacement interior fridge vent for a VW Vanagon Westfalia, with two 12V power socket mounts. The 45 degree sockets are necessary if you have something other than a stock fridge, since the aftermarket fridges take up…
This is a remix of DaGaLife's Tiguan wheel cap, for a VW Vanagon. Scaled up for a 56mm hole. The Vanagon's rear axle sticks out significantly past the wheel, so a tall cap is necessary to cover it. It holds OK by itself, but I added a…
I bought my Rav4 used, and the shifter unlock cover was missing. I dislike the factory one that requires a tool to remove, so I whipped up this. It fits reasonably snugly so it wont go flying out and is easy to lift out when you need to…
Edit: Added June 12 2026: Split into 3 parts for smaller printers. Edit2: Added June 22 2026, added flanges the 3 part split pieces to make it easier to glue together (more surface area at the joint) These valances are infamous for…
This is for the Gen 4 Smallcar AC dash kit. I didn't like the way that the air vents for the dash were hard up against the brake booster, and the subsequent super tight curves required. I have the large BMW booster, so its probably better…
The original Vanagon charcoal emissions canister has been NLA for a while. A replacement is available (1H0201801C) but the bottom vent is quite different. This adapter makes it easy to hook up a ¼" host in order to plumb it into the air…
Label plate for a Lenovo Tiny m920q or m720q. SHOULD fit an m710/910 with the same front grille. Friction fit, with a 2mm standoff to allow airflow behind it Printed in ABS, but any filament should work. No supports needed
Plug for various body locations on a Gen3 RAV4. Will probably fit many other Toyota models as well. Print in TPU for best results.
A holder for the Transcend Micro CPAP. This machine is very portable, but is kinda unstable due to its very small size and lack of corners. I designed this for hanging in my camper van, however it'll use any hook that fits through the…
This fits in the coin holder on Gen 3 RAV4s (2006, 2007, 2008, 2009, 2010, 2011, 2012). Holes for 2 20mm rocker-style switches. Print in at least PETG for temp resistance, I used ABS. Satin bumper trim paint matches the other black…
End cap from the rear ladder of a General Coach model 21 RV. Will very likely fit other ladders by the same manufacturer, but I only tested the one. Print in ABS or ASA for UV and temp resistance. Print upside down for no supports, or…
These are all currently available results.
