Counting matching models…
Zack Freedman’s original Gridfinity Base Plates https://thangs.com/designer/ZackFreedman/3d-model/Gridfinity%2520Baseplates-60925 I’m a big fan of Gridfinity and magnets but the crazy filament cost to print the weighted baseplates to…
Gridfinity block for the 4oz bottle of Super Lube. Doesn't interfere with blocks next to it.
Simple block to hold Heat-Set Insert Tips. Specifically the Ruthex set found here (no affiliation)
Simple block to hold the 20g stick of Loctite Anti-Seize
Boric Acid Hornet Trap – Kill the Nest, Not Just the Wasps Most traps only catch a few wasps. This one helps take out the whole colony . This design uses a boric acid that worker wasps carry back to the nest, spreading it and reducing the…
Original designer's control box didn't fit the hardware I purchased so I quickly modeled this up. My design is in no way polished. Proud of how snug the lid fits though. M3x8 screws to hold down the speed controller and some hot glue to…
BOM (1) arm from a 15mm binder clip (1) m3 bolt (<6mm preferred but if they are longer they can just run down the original clip holes (2+) 3/8" x ¼" neodymium magnets (Glue them in or they'll inevitably jump out) Bed Clip Alignment Remove…
Wanted to add casters to an existing shelf as I couldn't find a deep enough shelf with wheels readily available. Important note, only used for shelf assembled in half height configuration. Not sure it would be sturdy enough for full…
Replacement holder with a quick print Features: Secure fit for Kodak sensors Ergonomic shape for easier positioning Compact, lightweight design Quick, support-free print Material & Sterilization Notes Recommended materials: PETG – good…
Parts to print 1x Button 1x D-Pad Knob 1x Frame 1x Text Assembly Same as @atom's design I didn't go as fancy as @atom to create other buttons other than A. I can but on request.
These are all currently available results.
