Counting matching models…
Original f3d file is 2.5mm thickness but can just be extruded further. Original bracket is 30mm height and depth and 2.5mm thickness. SCALE IN SLICER Print orientation matters for better strength due to layer direction. For load bearing…
Flat bracket L=60mm, W=35mm countersunk holes.
Bolt holes are 35mm apart
Can be printed in both PLA and PETG. Neither model requires supports however the on with the slot for a charger prints better with supports enabled.
Screw mounted headphone holder with lip to prevent them from falling.
A piece to mount to bedside table to hold electric blanket remote.
30mm Cut-out diameter. 65mm Ring diameter. Should work fine with PLA unless light is filament bulb or tends to get warm to a point where warping of the PLA may become an issue.
No supports! I had to enlarge the stl in cura to 102.5% but it did fit just a bit tight at regular size. Chamfered cable entry to ensure reduced strain on the cable. Can be used without screws however not as stable. The usb extender is…
Currently just a prototype. In the STL, the larger ones fit on the back/arm of outdoor furniture. The smaller one is unt
Clamp for a pipe file I found on thingiverse pipe was scaled to 600%.
Untested model for a lightshade although it will definitely fit given that v3 is a remix of this model and dimensions are the same. Adjust wall thickness to change amount of shading. PLA will probably be ok for LED bulbs but anything else…
Remix of - https://www.thingiverse.com/thing:7022848 -
I wanted to use my laptop screen and my monitor without my laptop taking up desk space. 3 of these mounts securely hold
Modular shelf slides together into one when printed. no supports.
Guide for PTFE tubes if ace pro is stored on the right of the Anycubic Kobra 3/3v2
Holder/mount for laptop charging brick. Dimensions of charging brick pictured: 25mm depth, 135mm height, 75mm width
Replacement for the tools that come with replacement ear cups to aid with replacement.
Designed to stack two relatively standard pen pots although could be used for other things such as plant pots. Practical and decorative it is ideal for desks and small workspaces. Screw down for extra stability. Cubic infill 35%, Zig zag…
A hook with a flat base so it can be printed with supports.
Printed in matte black PLA. If non LED consider using a material with better heat resistance than PLA and adjust wall thickness and count accordingly.
Used for my creality ender 3v3se as my filament spool is externally mounted and I didn't want the runout sensor getting in the way or damaged.
Endcap for a usb hub from company 'Trust'. Original one broke so I designed an external one.
Scale and apply! Storage to be used underneath desks to provide extra space. Originally intended for build plates but can also be used for keyboards, laptops, workbooks and much more. Make sure to mirror the STL in the slicer as they are…
Has 3 screw holes however does work with command strips given that the plugs are not too bulky and there isn't excessive tension on the wires. PLA does work however it is more difficult to mount without snapping than PETG. (Pins are…
Stops filament spool from sliding off of holder if at an angle to the printer. f.3d file included so that if the clip is not quite big enough you can uses the "push/pull" command to stretch the outer face. Printed on 0.2mm nozzle so may…
A mount that slides onto [insert rudder model] and can have motors bolted to it. PETG 30-40% infill and waterproofing lacquer is advised to enhance strength and reduce risk of failure under load. I also bolted the piece directly onto the…
Holder for various screwdrivers to be mounted to desks, shelves etc.
Main body printed in PLA, stopper printed using TPU.
These are all currently available results.
