Counting matching models…
Arrow stand, should fit lost diameter arrow, with enough clearance between arrows so the hot melt doesn't stick to each other when installing points. Printed with pla at 10% infill to save material. Has 4 notches on the base for different…
Internal spool holder can fit spool up to thickness of 80mm. Two version, 2 piece version with the swapable cap to enable fitment of thicker spool or different size spool hole. Attached via m3 heat serts. Reverse bowden holder is attached…
This is a great project, made this to play SF6. Made some changes to the file to make the case for my usecase. Printed in PLA. 1.5mm layer height 20% infill, but honestly print setting isn't too critical for this. The wall around the…
Simple tool to stop your arrows from rolling off your scale, Printed in PLA at 10% in-fill to keep the added weight minimal. To find FOC, balance the arrow on the middle grove, slide the second one under the mid point of the arrow.…
Having too much fun with the chamfer tool on F360. Printable with 0.15 or 0.2 layer height. will fit any thin controller with less than 18mm thickness. i.e. Flatbox, Razer Kitzune, Junkfood micro. etc.
Based on the dimesion of Neutrik's Step file. shold fit snug if your printer is well calibrated. Added corner relief to the inner corner of the insert to help with the pressfit. Printed in PLA at 0.2mm layer height.
Curved Pick stand/holder, spaced out and shapped to allow access to my fat fingers. Should fit picks up to 2mm thick. 2 Version for 5 or 10 picks. Thank you!
Designed to fit the new enclosure 2.0, on a Vcore 300. I made this to stop my cats from reaching the wires from the side. should print well in any material since its basically a flat panel Includes two version of the bottom right panel,…
The print is functional and has been holding up pretty well in PLA but will prabably be better in PETG for the added flexablility and enviormental durability. Added two modified versions. one thicker at 9mm and one with a rounded hook…
CNC version, ordered for JLC PCB but I imaging it'll work with any companies out there. Follow the direction on https://github.com/jfedor2/flatbox/tree/master/hardware-rev5 for ordering. The finishe I used was “Bead blasting-100 mesh +…
M3 screw for mounting the pcb, screw directly into the printed parts Printed in PCB, enclosure side mounting designed for AFS enclosures. Fits Brook UFB or any other PCB with the same foot print like the RP2040 breakout boards.
Printed in PLA with 20% infill. The stem fit tight but if you press straight down down it should be okay, pull straight up to remove, do not wiggle. Slots on the side are there so you can use a regular switch puller to remove the caps.…
These are all currently available results.
