Counting matching models…
This trash can was made by using sine waves of varying frequencies to define the outside surface, giving it its rippled appearance. Slightly different sine waves were used on each side so that no two sides look the same. The ripples also…
Print approx. €8.06–€9.85 excl. taxPreliminary estimate for one variant
Use the threaded holes and studs to measure thread sizes on screws and nuts. Has the following thread sizes available: English coarse thread sizes: 1/4-20, 5/16-18, 3/8-16, 7/16-14, 1/2-13 English fine thread sizes: 14-28, 5/16-24,…
Print approx. €3.97–€4.85 excl. taxPreliminary estimate for one variant
Supports needed for the overhang - don't print flat side down or the swivel joint won't work. I used PLA, but most any material should work. If you like this design, consider checking out my Etsy shop for more cool prints. Use this link…
Print approx. €0.50–€0.61 excl. taxPreliminary estimate for one variant
Print with foaming TPU for a nice squishy hand squeezer, perfect for stress relief or building hand strength. Print Settings: Material: Foaming TPU (I use the TPU air from Siraya Tech) Infill: 25-40%, depending on how squishy or firm you…
Take your grip strength to the next level with this (mostly) 3D printed wrist roller! Printed parts: Clamp. I used PC blend for this, although it would probably work with other materials as well. Just don't use with PLA since that…
These are all currently available results.
