P
PrintablesFredrik
Voron 2.4 Canopy 300mm middle part
Just did a little bit of modifying to make the 300mm middle part from the original model printable flat on it's back just like the remixed 350mm version .
- Downloads
- 379
- Likes
- 34
- Rating
- 5
All models
Counting matching models…
P
PrintablesFredrik
Leviathan DIN mount
I wanted a beefier mount for my Leviathan board that doesn't use the standard Voron brackets that thread into plastic. This mount uses the brackets from @Maxstupo and heatserts for all mounting. Bill of materials (including bracket…
- Downloads
- 296
- Likes
- 27
- Rating
- 5
P
PrintablesFredrik
Bambu Lab Over-Engineered Y-Splitter_v2_3DSWay
These were the fittings i had laying around but they are quite a bit larger than the standard plastic collet. https://www.aliexpress.com/item/1005002680262764.html
- Downloads
- 258
- Likes
- 31
- Rating
- 5
P
PrintablesFredrik
XOL Toolhead Biqu Microprobe mount
With the "reboot" of the Mantis XOL 2 Toolhead by Armchair-Engineering it's now modular and quite simple to add mounting brackets for a wide range of probes. I needed one for the Biqu Microprobe so i threw something together for the…
- Downloads
- 62
- Likes
- 10
- Rating
- 0
P
PrintablesFredrik
Bento Box base for Ratrig VCore 3 300mm
Uses the same hole spacing as the floor panel. Mounts to the left of the rear rail.
- Downloads
- 48
- Likes
- 9
- Rating
- 5
P
PrintablesFredrik
Spacers for Whoppingpochard kinematic bed mount
So i printed the new Nevermore V6 carbon filter and it interfered with the kinematic bedmount. The simple solution was to print a 2mm spacer which does not protrude from the 2020 profile. Print with standard Voron settings (should result…
- Downloads
- 26
- Likes
- 14
- Rating
- 0
P
PrintablesFredrik
Electrolux/AEG/Ankarsrum Dough knife adapter
Since the dough knife is no longer sold as a spare part for machines older than N24 (-05) i had to make this adapter so that i could use the new knife ( 920900019 ) as a replacement. It's not a 1:1 replacement since the angle of the knife…
- Downloads
- 21
- Likes
- 5
- Rating
- 0
P
PrintablesFredrik
Raspberry CM5 IO Case stand
Simple desktop stand for the cm5 io case with cutouts for the rubber feets
- Downloads
- 19
- Likes
- 1
- Rating
- 0
P
PrintablesFredrik
Ratrig V-Core 3 flexplate align corners
Use M3x6mm screws with washer to fix the corners to the plate. Needs support. Step file contains built in support for multi material printers.
- Downloads
- 8
- Likes
- 2
- Rating
- 0
These are all currently available results.