Counting matching models…
Fits very well with the Protean Talon receiver and fits Worker talon 10 and 18 magazine. May work with other models but I cannot confirm. Does a good job of guiding in Talon magazine. I used two sets of 3m pan head 30mm screws and nuts .…
Used for pulling nerf flywheels that have been over pressed. (Unpopular opinion): I prefer to over press and then use this to work upwards and fine tune alignment especially with two stage setups, utilizing a very long hex key to really…
If you’re having trouble unloading magazines fast enough, this mod is for you. All the brilliance and modularity of the original protean with some fun tweaks. Rev-Core, A modular rate of fire mod. This mod uses swappable motor cartridges,…
Works, and looks good while doing it. used with microArc's wide versions of the Windowed Magwells linked below https://www.printables.com/model/812494-slab-v4-windowed-magwells
An isolated drop in trigger option that requires no other modifications to the blaster to function. Stop screws give the option for builders to limit or even stop travel, past the point of switch activation. I personally prefer more…
This bonsai pot was designed as a test to see how well a 3D printed planter holds up to outdoor conditions. I recommend printing the main body inverted with supports, so that all the overhang will be covered by the liner. I recommend…
-Two fully recessed screws that can be adjusted as needed to fill any gap between the pusher and the receiver units. Need two M3 30mm socket head screws. -Added an optional extra screw hole for top receiver rail so a more robust spring…
Bonsai Pot with incorporated drain mesh and wire holes. PETG is intended for the outdoor wet environments , and PLA is not. However my tests with PLA have held up this year so far using a high wall loop count. I Recommend printing with…
I have the Marineland Penguin Bio-wheel 200 (up to 50 gallon). If you have a different size filter, make sure to measure your tubing first. Extending tubing allows intake to moved to the opposite side of the tank to the output for more…
These are all currently available results.
