Counting matching models…
I watched the Mission Impossible the other night where they have the suction cups for climbing glass. It was much easier to do this mod in PS than get into cad. Sometimes i forget how powerful PS really is. Magnets should just push in…
Very simple Wrench Holder, prints without support. I used printer parts settings. 4 or 5 walls, 25% or so infill. Nothing secures it, but it's decently snug. I didn't have a T-nut that would fit that slot, so i can't guarantee it's…
I noticed while folding, the screw was not holding the assembly as rigid as i thought it should be. By making the boss that houses the screw, and the screw both 5mm longer, they are fully supported throughout the screw's travel. It will…
Updated with new 3rd model. New model is thicker and with a taper, better outside edges. Two short and one long styles. made to use 1/2-13 threads. The stub wrenches are thicker, and work better, will hold a little more torque. I turned…
This is a saucer dish for your Oddish planter. I printed mine at 200% scale. Enjoy!
I think this may be the best of all worlds in terms of ease of accessibility, maintenance, performance, noise, and motor shaft support. This idea really comes from several mods that have been thrown around the community for some time now.…
I cut 6mm from the Dragon mount and moved the screws up a little. I've got this up and running, works well. I'm using 2.5x8mm screws to mount the hotend, everything else is the same.
I have models for both 305 and 310mm bedsheets. Use the same bottom. You'll need to mirror each for a pair. I have been using these for quite some time now. I have made them out of both ABS and PETG, no noticeable difference. They work…
I made this to be funny since my overly long bearing shafts needed some justification. I'm surprised these girls don't have a headache. They must be pros. I printed 2 poles and mirrored the dancer in the slicer. for 5mm bearing shafts, no…
This is just a fancy washer I made for exposed bolt heads. Sorry, I couldn't seem to get a better picture.
Just a simple replacement button, to be printed in TPU or similar. I made three versions, one with varying thickness of the button to try to duplicate the original feel. I think i like the thinnest the best.
Until the O2S comes out, I'm not aware of a toolboard that runs USB, gives you another USB for Beacon, and 12v to run a decent 4028. It seems like there was one more feature I needed, but I can't think of it now. After trying a few…
Both the HoneyBadger and West3D buildsheets I have are 305mm square. I have an OSEQ that is 310, so i'll probably be updating this at some point. This uses the bottom pieces from the original, you might try scaling them to 100.5% or so,…
These are all currently available results.
