Counting matching models…
You can use this for dialing in your printer's attention to detail before a difficult print. Any material can be used, and you can scale it higher or lower to make it easier or harder for your printer.
It's a rectangle for adding a base to remixes of models or just need a base for your new design.
Again, I created this design on tinkercad and it didn't take me very long. So, if you have any concerns or notice anything wrong with the design, feel free to leave it in the comments. I would suggest PLA for this and obviously no…
I suggest 15% infill and print it just how its oriented. It took 1 hour and 3 min to print on 40mm/s with my Entina Tina 2 plus printer using PLA.
Same settings as v1, scale up or down to make it easier or harder for your printer, any filament can be used.
You can use this for when you don't have any change lying around to use and it's easy to customize. Settings: Filament: Any Scaling: Any Bed Temperature: 50 degrees Celsius
It's a ball and socket joint that's meant to be used as a fidget. Print settings Filament: PETG Adhesion: Raft Bed Temperature: 50 degrees Celsius Assembly Remove both pieces from the build plate and snap either side of the "ball" part…
Dreidel Duel Game Manual Spin once for chance, twice for glory ! Double Spin Dreidel takes the classic holiday game and adds a daring twist. Spin the Action Dreidel to set your move, then decide if you’ll risk the Multiplier Dreidel for…
Just print it how it comes, no supports necessary, scales well. I would probably recommend pla.
These are all currently available results.
