Counting matching models…
This simple tool makes it a bit easier to remove the plugs from the hotend without damaging any wiring, or putting undue strain on the printhead. The tool is used as follows. :- Heater: slide it over the plug and pull. Fan: push it over…
Our dog hurt his back and he had difficulty bending down to eat and drink. We needed to raise his bowls, but it was annoying and untidy having things lying around, especially when I want to clean the outdoor area. These bowl holders lay…
There are many reasons you may need, or want to deflate a tyre. This little gadget will deflate a tyre without causing any damage to the vehicle. It is a disposable tyre deflator cap. Just unscrew the valve cap and screw this on. Using…
The standard rollers for the S22 wear quickly. These TPU rollers are very tough. I have done over 2000km on them and they have shown negligible wear. The first versions were a little loose around the bearing and became worse with age, so…
This is a case for the Fnirsi 2C53T and 2C23T 3-in-1 multimeter, oscilloscope, signal generator. It will protect it from bumping and hopefully dropping. It allows full access to all ports and the stand can still be opened.
The SD Card is difficult to insert and remove without long fingernails, or tools and good eyesight. This simple tool aligns with the frame to push the SDCard in the required amount to lock it or release it.
The Google Chromecast TV remote control is too small, badly shaped to pick up and use and very slippery. It is an excercise in form over function in my opinion. This cover will make the remote easier to pick up and use. The remote simply…
The original Kingsong S22 sliders are subject to inward lateral pressure when coming off drops and jumps. This causes the bolt heads that hold the rollers to bind and scrape in the slider channels, causing high friction, scraping noises…
Strainer to put in concrete strip drain with 100mm drain pipe. It will stop leaves going into the drain. If the leaves build up around the strainer, water can still flow up and over the leaves into the open hole in the top with no…
This adapter works with my Kmart food hydrator, but providing the diameter is the same it should work with others. You place a 20L bucket upturned onto the ring so air can escape and flow through the enclosure. the stand sits around the…
This adapter will securely wall mount your charge adapter, if it is the type in the photograph. It is neat and elegant. The mounting hooks are printed so as to give maximum strength. I used PLA for the body as it is in my garage, but I…
This clip will reseal a bag with a straight edge. Simply fold over the edge of the bag and slide it on. It has a flare on the end to make it easy to slide. Print in PETG for best outcome.
Clips will hold the barbeque cover on, even in moderate wind. The slots have a small bump to ensure clip stays closed. The 3MF is configured with eSun ePLA-st, but I also print these in ASA without interface support material and they come…
Cover the front console and hide your items from prying eyes. I used a carbon fibre patterned plate to make it look a bit nicer. Printed in ASA.
This large pegbasket will hold many pegs and the divider allows you to create 2 (or more) compartments so you can have different peg types easily separated. Plenty of drainage. I printed the ends in PETG and the basket and joiner in…
Wife complained that her glasses kept sliding out of the tray in her Megane E-tech. I printed this little tray in TPU to make it less slippery with higher sides.
These are all currently available results.
