Counting matching models…
Using a painter's pole for an antenna mast? You need an end to screw on securely to hang a wire or carabiner? This oughta work for you. The internal threads should match your painter's pole… matches my LongArm Painter's Pole I got at…
What are you puting on the end of that nice Wimo Heavy duty mast? Rubber bands? Electrical tape? Here's a better option. Use for inverted V, verticals, random wire, or whatever. There's a groove inside for an o-ring if you want extra…
Mr LongArm has big locking collars, but you need to land a guy ring above the fiberglass section. Use this. Print 3 of these. Turn on support for printing the male part of the dovetail. Assemble with 2 already snapped together, slip it…
Download the .pdf file too . Drawing and Bill of Material!!! I built this prototype for a touch paddle, and it works great. This is ham radio baby! No warranties, guarantees or otherwise. As always, you're on your own! Make your…
Lower is a little larger ID for lower sections of mast, Upper is a little smaller ID for higher section of mast. 3/8 holes, 120 degrees apart.
If you have a Nomad23 from DX Engineering, you need this tip to hang your wire or whatever. Pictured with polystealth wire, little fingers to hang onto that wire while you're working your favorite portable contacts. Prints easy, no BS,…
My CW Morse Paddle paddles warped from the heat in my car-just the paddles. The box/housing for it was fine, but the paddles themselves warped badly. My sending isn't that great anyway, so throw a warped 3d printed paddle in the mix and…
The Eagle5 microswitch paddle. You're cheaper than I am, and you don't care if the paddle is a little crude as long as it's reliable. Well, maybe this one's for you. You'll have less than $2 in this one, and it's easy. A little “clicky”…
These are all currently available results.
