Counting matching models…
I remixed haphazardlynamed's designs to allow them to be used with button head bolts and also added versions that use 25mm bolts (button head compatible too). I also cleaned up a few artifacts that were present in the original that would…
I made several variations of the original design by haphazardlynamed. Also, it requires an M5 nut and M5x16mm bolt (the original post says 10mm but that was too short). I've added versions that are Aeon Pro compatible Made for 17/32"…
Hardware required and install instructions are same as the original
The original model did not have enough overlap where it widened to the N-strike attachment portion. This resulted in the print snapping very easily at that point. I have thickened the design slightly at that point. It still works just…
The original version did not align properly for me. I believe I have the holes aligned spot-on in this remix I made. I also have included a version for 17/32" brass. Let me know if it doesn't work for you and I can take a second look.
Currently at v1.0 Print at 0.28mm layer height (base is 0.84mm = 3 * 0.28mm) Peg goes into slot on trigger behind the screw post (limiting the return travel and therefore the distance required to release the catch from starting position).…
These are all currently available results.
