P
PrintablesZ B
ESP32-S3 44P DevKit Case
Resized for 44 pin dual USB C devkit board
- Downloads
- 539
- Likes
- 30
- Rating
- 5
All models
Counting matching models…
P
PrintablesZ B
Elegoo Centauri Carbon Bento Box base - no heat inserts
Modified base for the bento box, taking bits and pieces of other mods. This version has a cutout to sit flat against the wall of the CC, has had the heat inserts replaced with self threading M3 capture holes, and has 6 inserts for 6x3…
- Downloads
- 151
- Likes
- 33
- Rating
- 5
P
PrintablesZ B
Centauri Carbon riser remix - no sliding top, no gaps for heat retention
This is a remix of the original to address a few issues I had: Cover was sliding off the back on some long prints due to vibrations Extruded the lip to match the front two pieces to fully retain the glass top PTFE guide was allowing too…
- Downloads
- 122
- Likes
- 11
- Rating
- 3
P
PrintablesZ B
Centauri Carbon wire guard with 6x3 magnets
Remix of the original using 6x3 magnets
- Downloads
- 30
- Likes
- 9
- Rating
- 5
P
PrintablesZ B
1mm Magnet Wafers/Spacers
These wafers allow for 1mm compensation for disk magnets. If all you have are 8x2mm, but a design calls for 8x3, drop one of these in first before press-fitting the magnet. I usually run this plate when I have a tiny bit of a spool left…
- Downloads
- 12
- Likes
- 2
- Rating
- 0
P
PrintablesZ B
Parametric TUSH stand for different spool sizes
Parameter ‘SpoolWidth’ can be changed to make any spool sit right in the middle of the bearings. Measurement is from middle of spool edge to middle of spool edge
- Downloads
- 3
- Likes
- 1
- Rating
- 0
These are all currently available results.