Counting matching models…
Oct 14, 2026 - Please don't print this model. The design is flawed; the retaining clips break off, making the dowel section useless. This will be redesigned to use a threaded attachment instead, hopefully within the next week (~Oct 21,…
2mm walls with 7% grid infill were adequate to print this. I used 3x 30mm M5 socket head bolts, but the hardware required may vary depending on manufacturer/model: I've seen other models with the same bolt pattern use wood screws. The…
My wife felt nostalgic with the re-release of the McDonald's Happy Pails, so I made smaller versions. You can use them to hold stuff (candy) throughout the house, or you can chuck a tea light in them as decorations. The lids are all…
This is a strain relief arm based off of Voxel3D_Nederland's slide over concept. I did my best to minimize any play from the bed moving, and I think I accomplished that. This is designed for for beds that have the center of the wiring…
My solution to the stock handle, where the tabs break over time. This design uses a shim instead, so it shouldn't break. The ABS and ASA models have tags, in case you print multiple materials in the same color. Scale to 102% for ABS and…
These swatches can help you figure out the layer height you want for flat translucent prints. The left column is the thinnest layer height, the middle column is the thickness noted, and the third column is the thickest layer height. Print…
The Suntour XCR 32 rebuild kit includes the seals, but no tool to press them into the fork. This tool is the proper diameter to fit around the top of the seal and set it using a rubber mallet. The tool overhangs the outer edge of the…
I like the design of the pot, but I wanted something to contain excess water. Here it is.
This is a drill attachment to refill empty Auto Feed Spools (AFS) using .065" replacement trimmer line. I originally created this to cut down on waste, but the trimmer line I used to refill the spools actually seems to last longer than…
This is a mount for the RainPoint ITV405-DLS timer. I wasn't able to mount the timer directly to the faucet head, because my faucet was too low to the ground. This mount allowed me to attach the timer to a hose and mount it remotely. A…
A (totally unnecessary) tool for D2 coil adjustment collars. This held up to my dewalt impact gun prior to the bolt shearing off. Use a high infill, 60-70%+. Useful for working the collars off the car.
A plug/cap for D2 rear spring perch body. Normally, the top is left open, and there's nowhere for the water to drain. Consequently, water pools up, rusts the bolt, and next thing you know, your drilling stuff. This is an attempt to…
These are all currently available results.
