Counting matching models…
Introduction I used Zerdino's bumper design on my Luba 2 AWD 2024 to be able to mow closer to my lawn-edge-stones at the rim of my lawn. The original bumper will not hit them as they are too low. So I used his model and it worked fine.…
Gardinenhaken zur Befestigung an Ringen mit 10mm Stärke. Einfach und schnell zu drucken und sehr stabil. Druckeinstellungen: PLA 0,2mm Schichthöhe Infill: 100% / massiv drucken 5 Wände, Obere / Untere Schicht 4 Muster der unteren / oberen…
English Version The original model had a small inset on both sides. to put the paper-printed-labels into it. It needed supports to print that. When the inset is smaller than your layer height, you might run into problems with support…
Remix of PhilippSorenses's remix of PsychProd's original. I had the small issue, that my silica gel beads / pearls were uneven in size and sometimes broken. That led to a lot of them falling through the main container's wall. I slightly…
Product info German discounter NORMA regularly sells small-parts-organizers by KRAFT WERKZEUGE (Kraft Tools). While most of these are the usual crappy, thin and flimsy “Chinesium” stuff that we all know quite too well, they sometimes also…
Replacement timer-knob for an AEG AF 5-1-4 air fryer. The original ones unfortunately break of very easily, especially when you manually turn back the clock to zero (you shouldn't do this) I printed them in PETG, 0,2mm, 2 walls, 4 top, 4…
*** german below *** EN: Needed to mount a Blink Outdoor camera to a 40x60mm fence post. As I didn't want to damage the post by drilling into it, I made this bracket. Its printed narrower on the open side, so It snaps nicely into place…
The more you print, the less impact do the manual filament changes have. You have to do 12 changes on the bottom, and 12 on the top. Manageable. Printed in 0,2mm PLA
These are all currently available results.
