Counting matching models…
A cover to protect the CLEAN button of an iRobot Roomba (mine is an i7, should fit on others too). Might work great against curious cats. The button is still accessible through the hole. I attached it with double-sided adhesive tape.
This is a stand for the IKEA STAVE mirror. It's tight enough for attaching it without glue/screws/adhesive tape but scratches on the frame are possible. Upscaling is recommended for an undamaged frame. Tested in landscape format.
Toniebox USB-C PD Charger Tired of carrying the Toniebox charging station with its fixed power adapter when traveling, I switched to a USB-C PD cable with a barrel plug to get the required 9V. It worked, but the straight connector…
Case for a DIY smart meter sensor Inludes holes for a 3mm phototransistor and two 5x5x5mm magnets at the bottom. I also made a large cutout for a ~10mm wide screw terminal. Electronics (german): by Paul Görgen and some Informations (the…
A wall mount for TP-Link VX231v. The short brackets maintain the dimensions of the original design from @bensen . The longer version is designed to mount the router above its power supply.
Printed in PETG with organic supports.
The bottom part can be printed as is. Print the top part with the display side facing down, without supports.
This cable inlet is designed for the Create Wind Large ceiling fan. To install it correctly, place the ring between the canopy and the ceiling. Additionally, use the spacers between the fan mounting bracket and the ceiling to adjust for…
This is a wall to prevent robot vacuums from trying to climb up the foot of the Reer 1909 changing table heater. The foot has a diameter of 50cm so the wall should suit any other thing with this dimension. Printing 8 of these should give…
These are all currently available results.
