Counting matching models…
Pressure fit potentiometer knob for a potentiometer with a 6mm shaft Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.2 Infill: 20% Filament: 3d Jake PLA Notes: Depending on the bedadhesion you…
With this model you can store your in ears on your skadis pegboard. I really liked the T-Nut system created by 6d6178 therfore you need to print two of his M2.5 T-nuts to mount this. The mount was designed to store the case with some kind…
With these 2 parts printed in FDM or SLA you can magnetically attach and detach a hose to extract the fume from the Photon Mono SE (and probably other Photon Monos but I only tested on the SE). I used an instruction to redirect the fumes…
You only need 4 strings I used 4 different colored ones with a length of 20 cm but you can try which length works the best. Tie one string around each edge of the board and than you can use it to images the game tells you to represent
I remixed this nice gnome model to be used on a standard presta valve.
To build the spicerack you need : the 2 printed mounts (the normal and the mirrored side) 2 rods (I used wooden rods with a 5mm diameter) 1 plank (I used a wooden 10mm thick and 60mm width board) adhesive strips or 4mm woodscrews Cut the…
Small clip to secure cable under bottlecage
You can store your Padholder underneath a shelf to save space and do not lose them. Just screw it down with 3 small screws. It should fit for all standard Senseo Padholder. To use it with some special padholder which are slightly bigger…
I needed a way to mount my bitset beside my screwdriver, thererfore I designed this simple solution using the t nuts. The holder should be printed with the open side up, it should already be oriented that way. You additionally need two of…
Stemspacer for the standard 28.6mm (1 1/8″) stem 28.6mm (1 1/8″). Disclaimer: I did not test sufficiently if the 3d printed spacers are strong enough so print them at your own risk. I just used them to build the bike and later replaced…
This is a small cable and simple cableclip for bikes with external cable routing. It secures the cables under the bottlecage or even without a bottlecage. It reduces rattling and makes the cable routing look more clean. The clip workes…
These are all currently available results.
