Counting matching models…
This small shelf holds my coffee paraphernalia and is comprised of 2 3D printed legs and a plywood board. I attached self adhesive rubber feet to the bottom to prevent any wobbling/sliding. The legs are 200mm high and have 2 screw holes…
This tool is the result of an in-depth research project, centred on designing a tool to assist users opening and closing plastic jerry cans. It incorporates the current best practices of ergonomic handle design, to benefit those with…
Designed this funnel for used 50ml centrifuge tubes that have become ubiquitous in the specialty coffee community. Tolerances are not tight so you should not need to worry about resizing. (External diameter of tip of funnel is about…
Most available models incorporate the charger, which is not what I wanted as the brush has very good battery life. I have only tested this with 5300, but believe it would work with 5000 / 6000 / 7000 series brushes. Designed to be…
Designed to mount using 3M VHB tape / command strips, or similar. It is not a tight fit so don't worry about scaling the model Print in PLA or PETG. I used 0.24mm layer height with 0.6mm nozzle but most combinations would work.
Designed for my 1ZPresso Q2S but may work on other grinders. The tip of the funnel is approx. 42mm external diameter so if your grinder is larger you might be in luck. Height from narrowest point of cone to tip of funnel externally is…
Provided case was boxy, so I wanted to enhance aesthetics - taking inspiration from the Braun DN40 and Scott Yu-Jan's subsequent iPhone dock. Original case required soldering to the display header pins and the ESP32's PCB directly. This…
This design mounts to a wall/cupboard door to hold reusable food/freezer/fridge bags. The dimensions were based off of these bags but others may work too. The 4 bags of each size fit comfortably. The front divider is 89mm high and the…
The Hario Mini Mill makes an ideal pepper grinder, blowing many dedicated pepper grinders out of the water, as it outputs a lot of pepper for each turn of the handle. The adjustable grind size is also nice to have, of course. This design…
Tamper stand modelled as a scaled down version of the national / world barista championship trophies. 3 tier / 1st place UKBC trophy but scaled down to be more practical to print. 2 size options - small is shown in the picture. Prints…
These are all currently available results.
