Counting matching models…
Cleaned up the AR152 exoskeleton design by Sigint Systems. Internal surfaces are now parametrically defined instead of a boolean subtract of a mesh. This means a cleaner file that needs fewer supports and support blockers to print cleanly.
A simple snap-in bracket to mount Daylight On A Stick (https://github.com/VoronDesign/Voron-Hardware/tree/master/Daylight) or similar LED strip PCBs to a 3030 extrusion at a 45 degree angle. Requires one “Voron-spec” heat-set insert (OD:…
Not a fan of screwing into plastic or square nuts, and I wanted some spots to mount an ADXL. CFD optimized duct gets a nutsert for the Probe mount and an ADXL mount on the rear. Hotend mount gets some fan nutserts (no more stripping those…
This is a 2-piece mount for a Logitech C920 or C930 webcam, allowing it to mount to either 2020 or 3030 extrusion at the top of your printer. To use this mount, you will need to disassemble your webcam until the point where you remove the…
A simple wall mount for the Nvidia Shield TV Pro. Mounts “upside down” compared to most mounts I found (IO towards the top on the right side). Prints without supports, uses approx 4mm countersunk screws to mount to a pair of drywall…
A bracket to mount the BigTreeTech HDMI5 display to the left side of a Ratrig V-Core 4. The main bracket can be mirrored to mount the display on the right side instead. BOM In addition to the two printed parts, you will need: BigTreeTech…
These are all currently available results.
