7 models
Material: 1x TP4056 board 2x wire, about 20 cm each 6x M3 x 10 1x M3 x 12 1x M3 x 6 3x M3 Nut 1x Spring that fit on the M3 bolt 2x aluminum cutouts measuring approximately 12 x 22 mm; I took mine from a well-known energy drink can 1x…
Print approx. €1.20–€1.47 excl. taxPreliminary estimate for PETGSource material: PET
I really liked the design but I made some changes --------------------[ Dimension ]-------------------- The large stem is 20mm The small one is 10mm The gap between the two is 23mm The total height is 32mm, with a 7mm base…
The brackets have an internal diameter of 34mm; the lightsaber handle in the photo is 31.5mm. The screw holes are 4mm. You will need 2 of these, either with or without walls, depending on your needs.
Print without any support Height: 20 mm Diameter: 16 mm
Print the side with the wifi icon facing the plate With this "upgrade," my printer no longer loses Wi-Fi. I can't say how much the actual gain is, but I went from struggling to connect to having it already connected as soon as I turned it…
LED bar : 17.5 mm x 7 mm Wires external diameter : 1.7 mm 2x M3 x 18 mm screws The bar fits tightly, I don't think larger sizes would fit, but the wires I used fit quite well, so I think slightly larger sizes would fit.
The height is 64mm, so they should fit into most spool boxes. The vertical walls are 0.86 mm, the thickness recommended by Prusa Slicer for 2 perimeters and a layer height of 0.20 mm. The horizontal walls are 1.00 mm, so.. for them I used…
These are all currently available results.
