11 models
Update October 12th 2022: Added V2 F3D file for remix. Update October 8th 2022: Added V3. Mounting slots are longer and thicker. Added ziptie slots for front left fan's wires. I haven't tested it yet. Update September 4th 2022: Adjusted…
Designed from scratch with thinner vanes and a 3" deep hole to fit a 5/16" wood dowel (Home Depot). Vane is about 3 3/4" long. I recommend increasing printing flow to 102% as I've experienced a bit of underextruding. I recommend attaching…
A cap designed to cover Aerogarden empty pod holes. It should prevent algae growth in the tank. 15-20% Cubic infill works well at 0.2mm later height. I will add print pics soon
I couldn't find any individual fletching models anywhere so I decided to design my own. Can be glued to an arrow using super glue or fletching tape. I have NOT tested it yet. Print Settings Printer: Ender 3 Rafts: No Supports: No…
Fletching that fits a 7.9mm (5/16") rod perfectly. Vanes are slightly (2 degrees) angled for speed and accuracy increase. Works great - have been tested. Print Settings Printer: Ender 3 Rafts: Yes Supports: No Resolution: 0.2mm Infill:…
4" fletching that can be printed in vase mode (Cura 3.40) with 0.4mm wall and a raft. It fits a 7.9mm (5/16") wooden dowel. Tested - Works great. I will try printing it with TPU. You might need to change the scaling a bit, stop printing…
Just another helping hands model that most suits my needs. It has embedded threads that would fit the popular coolant pipes. Scaled perfectly for printing with my Ender 3. There are four 5mm holes for attaching it with screws to a piece…
Arrow point cover for practicing knocking down bottles and what not. Can be printed from TPU with 20% infill as well for extra cushioning. Both caps fit perfectly my bullet and field points. Category: Sport & Outdoors
Very easy fast to print quarterly divided shallow screw cup with clip. Print the cups with 2 bottom layer, 0.6mm walls, 0.3mm layer height. 15 minutes each at 60mm/s. I can fit all four cups on my Neptune 3's bed printing them one at a…
Two types of small cups I use to hold screws. Pause at line 20 to add sand for for heavy bottom. Turn off fan 1-2 layers after adding the sand. Otherwise it will get blown everywhere (ask me how I know). Keep the infill at 5%. Print…
I designed this quick print (less than 20 minutes) Z rod cover for my Neptune 3 to avoid getting grease from the rod on my hands when loading a new filament. A note: depends on your filament holder configuration, it might hit the filament…
These are all currently available results.
