Counting matching models…
Remix of a remix of a postcard holder design that wasn't on this page yet. I quite liked the triangular design but changed the angle of the postcard to make it more stable and slimmed the part a bit to make it sleeker and use less…
I quite liked the original design (https://www.printables.com/model/396136-caliper-attachments-for-measuring-distances-betwee) to adapt my standard digital calipers to measure the distance between holes which I always had to guesstimate…
We use these holders anywhere where horizontal space for pipette stands is limited, in small rooms, inside flow benches etc. (Or when are in ship-board labs foir marine research where classic pipette stands tend to fall over regularly,…
The syringes of flux for soldering I ordered came with caps and needles, but to seal them, you'd have to take off the needle. Since that would just get lost, I usually left them unsealed with the needle on, resulting in a mess of flux on…
I lost the lens cap for my Nikon 14-24 mm wide angle lens in strong wind, so I figured rather than spending a fortune on a piece of plastic, I'd just print one and found a model on thingiverse. It works great and I really like the locking…
Adapter to integrate Weller silicone holder for brass sponge into PH 70 safety rest for soldering iron.
These simple organizers hold label casettes for the Dymo Rhino Labelmakers (models 4200, 5200, 6000, 6000+). One design is for ten 12 mm casettes and the other for five 12mm and three 19 mm casettes.
We use these sensors in our custom autosampler setup to detect fluid at different stages. Required materials: PTFE tubing (1.6 mm OD, 1 mm ID) 0.4mm gold-plated wire (from art supply) Superglue Epoxy resin cable with at least 3 wires…
These are all currently available results.
