In-Line Conductivity Sensor for 1.6 mm PTFE-tubing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A basic sensor for detecting fluid in tubing and measure its conductivity using an Arduino or similar.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 56
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
We use these sensors in our custom autosampler setup to detect fluid at different stages.
Required materials:
- PTFE tubing (1.6 mm OD, 1 mm ID)
- 0.4mm gold-plated wire (from art supply)
- Superglue
- Epoxy resin
- cable with at least 3 wires
- reference resistor (eg. 1 or 10 Megaohm)
- Arduino or similar
- needle
This design will need to be resin-printed.
Assembly:
- insert PTFE-tubing
- poke holes through the tubing for the wire using a needle
- insert two pieces of the gold-plated wire through to the long chamber
- insert cable and solder together with the resistor and gold-plated wires in a voltage-divider circuit (see picture)
- seal the openings around the tubing and wires with super glue
- fill the large cavity with the resistor circuit and the two cavities where the wires go through the tubing with epoxy resin. Do not fill the other cavities. It's impossible to get a perfect seal around the PTFE, so there will be a tiny amount of leakage. The quantity is negligible and not even visible. But over time it can build up enough to create an electrical connection that bypasses the tubing and throws off all measurements. The air gaps ensure isolation between the wires and the rest of the circuit.
The sensor works as mentioned above with a voltage division circuit. Wire it to apply a constant voltage (e.g. 5 V) across the resistor and the two wires (imagine the fluid in the tube between the two wires being the second resistor). Then just use an input pin to measure the voltage either across the reference resistor or across the two wires. The applied voltage is divided according to the ratio of the two resistors, so based on the applied and measured voltage and the known value of the reference resistor, you can calculate the resistance of the fluid between the two wires. Choose the value of the reference resistor roughly in a similar range of what you expect to measure. We only need the sensor to detect presence/absence of fluid, so I have not tested precision of the measurements or drift over time. But we are getting very good sensitivity as with a 10 Megaohm resistor, we can reliably detect ultrapure water (>18.2 Megaohm/cm) even after extensive rinsing.
As sensors like this are typically integrated with other devices, I'm not including my code here, but if you need help with the circuit or programming for the measurement, feel free to contact me :).