Counting matching models…
Same as original model except now the only 2 screws needed are for the fan. I used 20mm self taping m3 screws with a m3 washer! It amazing how much of the ghosting at higher print speeds is reduced with the reduction of weight in the mod…
My Thanks the the Multiboard Team over at Multiboard.io if you haven't checked them out then you should. all parts were printed on a Centauri carbon using Elegoo PLA Rapid Plus with standard settings. no supports are required. I will not…
couldn't find a bathroom pass. idk if they even do this anymore but modeled after a wooden one i remembered from high school!
Magnets are 6mm x 6mm link below. the fit is very tight so no glue needed. this is an update to my previous remix that removes more weight and added the larger magnets for a much better hold. magnets can be found here…
Best printed in TPU90-95A or nylon pa12. the tpu fits better but the nylon feels a bit better. Should fit P224-229 Mags that are 12 rounds might fit 15 round with a little playing
a 1/4-20 bolt lock in the back giving you a mounting point for any speaker or other device you want mounted to the wall plate. the ½" hole gives you a spot to run the speaker wires into the socket box. i found that ¼-20 x ½ or x 5/8 works…
These are all currently available results.
