15 models
UPDATE 9/18/25: Fixed the incorrect circle number (3/16 → 3/8). So sorry for the inaccuracy! The print photo is now outdated but only for the circle measurement. Also removed the 3MF files because they were generated by Fusion 360 and…
This is a custom model of the Kingdom Key from Kingdom Hearts made in Blender. Pictured prints are 25%, 50%, and 100% scale. May need to be printed with supports based on the scale of the print. If supports are used, you may need to pry…
A custom Kingdom Hearts logo for any use! Keychain, wall art, jewelry, etc. No supports needed. Print the connected version if you want to hang the logo from a chain, string, or nail. These models were initially designed for rendering…
A custom Kingdom Hearts Heartless logo for any use! Keychain, wall art, jewelry, etc. No supports needed. This model was initially designed for rendering rather than printing, so you may not be able to print the corners at their maximum…
A custom Kingdom Hearts Nobody logo for any use! Keychain, wall art, jewelry, etc. No supports needed. This model was initially designed for rendering rather than printing, so you may not be able to print the corners at their maximum…
This is an Allen wrench holder for the wrenches included with the Ender 3 V3 SE. The holes are for 4mm, 3mm, 2.5mm, 2mm, and 1.5mm wrenches.
I bought a cheap airbrush with a non-standard M9x0.5 interior thread for the cup, so I modeled one to replace what I was missing. No cap included and the cup is just what looked good rather than any specific measurements. If you want to…
This is a knob designed to fit #10-24 thin profile hex nuts. Nuts are friction fit, but heat may be used as well. While glue isn't necessary, it may help the nuts stay put in high stress situations. Make was printed with 3 perimeters and…
This is a tiny cap (<0.5 g at 0.24mm layer height) to fit over your pointed tweezers. No more poked fingers! The bottom inner diameter is 5mm and the top is 0.4mm to maximize how much the tweezers close. The interior length is 2 cm. A…
This is a simple cap for your Pittsburgh brand needle nose pliers. Print with the hole facing up to avoid supports. Pictured make is in PLA+ with 0.24mm layer height.
If the figurine is tight (3D printed/snap fit/etc.), I recommend removing the thin layers on the flat sides so they don't break off inside the body. I printed with the gyroid sparse infill pattern to balance strength on all axes.
Features Round, oval, square, or rectangular bases Common diameter and height presets Custom dimensions Chamfer the top edge Taper the top or bottom Hollow the top or bottom with customizable depths and margins Add a rectangular slot with…
This foot was designed for vintage Lakewood 202 box fans, but you may be able to fit it on other box fans. The included feet clip the fan onto the edge of windowsills. The pictured make was printed in PLA at Draft resolution, though PETG…
This model is based off of RemiRafael's airbrush nozzle remover ( https://www.printables.com/model/359513-airbrush-tip-remover ) but was rebuilt from scratch in Autodesk Fusion to include a keychain attachment ring. Print with the ring…
This is a cable clip with headset rest for mic booms with arms that are around 10.5mm in width and height. It also includes a headset rest on top for headsets up to 4cm wide. It clips on firmly but with some wiggle room and ability to…
These are all currently available results.
