Counting matching models…
This is a cue shaper that uses sand paper strips. This is a "Dime & Nickel Radius". Just cut strips of sandpaper and insert into the tool. Use the 2 sides (print 2 of the sides) to hold the tool together. Printed in PLA with supports…
A scraper that used standard utility blades. Print with no supports. I use this for cleaning the glass on an aquarium. The wood dowel is 10mm.
IMPROVED VERSION HERE. https://www.thingiverse.com/thing:2544386 This is designed in Fusion360. Uses 2 AA batteries and flickering 3volt candle lights. Use clear PLA for the torch top. PLA for the bottom. Print it with the battery door in…
My can opener does not cut the lid off the can, so I can't use the lid to squeeze the juice out for the cats. This device works well. I printed in food grade ABS at .2mm and 30% infill on flashforge creator pro. Printed in green abs,…
Uses ¼ bolt and nut. Print on edge, no supports.
This is a quick adjust clamp. It uses a washer on an angle to provide the quick adjust. You will require 3/8 threaded rod any length 3 - 3/8 bolts 1 - 3/8 washer (outside diameter is about 1 inch) 2 - 5/16 washer (goes on the handle) The…
New design - Shorter with sliding battery door! This is designed in Fusion360. Uses 2 AA batteries and flickering 3volt candle lights. Use clear PLA for the torch top. PLA for the bottom. Print it with the battery door in place, there is…
Improved version https://www.thingiverse.com/thing:2504647 This is a miniature Mine-craft Torch. I used some cheap flickering tea lights for the leds and a the switch. This torch requires soldering and a hot glue gun. The top and bottom…
This is for the Fluval Flex 32.5 gallon aquarium. This has two removable screens, that are held in place with the wedges on the side. I use Bio balls in the bottom, carbon in the middle and a filter mesh on the top. This is a snug fit,…
Here is the new updated version without a base, if you want to hang the feeder http://www.thingiverse.com/thing:2181266 Here is a bird feeder to screw on the bottom of an apple juice bottle you get at Wallmart…
This adapter is for mounting a sprocket for a gas powered bicycle on the rear wheel. This keeps the sprocket centered and in alignment when installing. Much easier to use than the traditional rubber spacers from gas bicycle kits. Use…
Redesigned and much improved, with included perch. This is an updated version of this https://www.thingiverse.com/thing:2181266 Here is a bird feeder to screw on the bottom of an apple juice bottle you buy at Wallmart…
This is a replacement nozzle for a caretaker99 caretaker 99 pool floor cleaner jet. There are two sizes here. An 11mm and a 7mm. I am not sure how many gpm they do. I just measured my old ones and made the one I needed. Print them with no…
These are all currently available results.
