LayersFactory

All models

Sort order

Counting matching models…

P
PrintablesPrints Turns

Back Panels Reduced

See remixed instructions

Downloads
16
Likes
5
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Sears & Roebuck 10 Speed trolling motor transom mount

Allows for the u bolt with spring to reattach to this transom mount, so you can adjust it to be out of the water, or placed back in the water. This is my third revision and has lasted over 5 years in PETG.

Downloads
13
Likes
1
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Knife sharpener helper

https://www.amazon.com/DMT-D8F-Dia-Sharp-Continuous-Diamond/dp/B0009H5C5M?th=1https://www.amazon.com/DMT-D8F-Dia-Sharp-Continuous-Diamond/dp/B0009H5C5M?th=1 This is made for the 8" continuous stone made by DMT. Print this with the knife…

Downloads
12
Likes
0
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Wall mounted Logitech BCC950

Use whatever settings you'd like, I recommend a higher infill so that way it is rigid. No supports needed.

Downloads
12
Likes
1
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Soundbar TV Mount

I printed this with 35% infill w/4 walls. Print with supports.

Downloads
10
Likes
0
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Raspberry pi 4b enclosure for waveshare with m10q-5883 gps

the pegs are press fit, if you want you could put a little bit of glue in there to help secure it.

Downloads
4
Likes
1
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Surface Pro Pen Holder

Print on its side so you don't need supports. This holds the pen while securely holding onto the side of the Surface Pro. Good if you got an aftermarket pen, or simply no magnets.

Downloads
4
Likes
0
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Custom Electric Unicycle controller mount

This was made with a CNC machine but I suspect pa12 or pa6 would do well, even PC. This holds an electronic unicycle controller board. The aim of this project was to create a custom electronic unicycle that has a 200 mile range.

Downloads
3
Likes
0
Rating
0
Order a print of this model
P
PrintablesPrints Turns

Chitubox 250w heater mount

This is a heater mount for the Chitubox 250w heater, angled in such a way, so it blows heat towards the opposite end. Mounted to the rear, back enclosure panel for the Sovol SV08, lower left hand side. I use a custom 3d printed enclosure…

Downloads
2
Likes
0
Rating
0
Order a print of this model

These are all currently available results.