Counting matching models…
I haven't found a satisfactory stand for my LEGO cars, one that could display cars on shelf at an angle and possibly be wall-mountable that wouldn't be tied to just one set. Cue my solution: elegant design that fits standard LEGO…
The mount is designed to work with 20 series extrusions and M5 screw + T-slot nut use 2 pairs and M5x8 or M5x10 Print in preferred filament, larger layer heights print faster (12 min @ 0.4mm, 20 min @ 0.3mm). Can be printed either “as…
Since EBB36 sports a rounded aesthetic I decided I should dip (and apparently sink) into the motif. After many hours in CAD and uncountable number of energy drinks this piece of engineering was made. Aptly named Cuckoo clock, for the…
Meow :3 Please refer to ERCF/ERF repo for instructions. Print file in the orientation without supports, using standard Voron settings.
Print instructions Supports Needed: No, Bed Plate Adhesion Needed: None, Print Orientation: Print upright with the bottom on the build plate, Materials: PLA, PET-G, etc.
I was annoyed with my partner putting vape mod in cup holder and it constantly rattling around, leaking if left leaning for too long and worst of all: forcing me to hold any drinks when I'm a passenger because vape hogs one entire cup…
Cable duct for Voron V0.1 or V0.2 that houses the Klipper Expander. Klipper Expander allows you to add additional functionality to your V0 / V0.1 when using an SKR Mini or SKR Pio board. It's mounted to the rear panel using VHB tape. The…
I remixed the model using original Voron CAD models, since the skirts were at completely wrong scale to the whole 3D printer. Skirt STLs need to be flipped after importing into slicer. I also added Multibody variant of the faceplate if…
Fits inside standard 12V car socket and holds on to the vape mod snuggly. Designed to be printed without supports in PETG or ABS/ASA, PLA should be avoided as it will warp or otherwise fail in a hot car. Print model in downloaded…
I designed a coaster using layers of overlapping bridges strung around outer frame holding drinks slightly off the surface of a table/desk. Print STL in downloaded orientation with no supports. I also included a tiny easter egg in the…
Case for Mini UART TTL Serial board off AliExpress. Labels and voltage switch are accessible through top cutouts. BOM: 2pcs M2×10 (or ×8) screws UART TTL board – https://s.click.aliexpress.com/e/_c4tWRnxx Be careful while printing, as…
These are all currently available results.
