Counting matching models…
This is a very simple rack mount for Ubiquiti EdgeRouter X SFP as well as its power brick. I did not want to deal with too much tolerances so I designed it around cable ties, which is functional but a bit crude. You will also need two M5…
This is a remix of the double doorway with bulkhead by Eberleg found here: https://www.thingiverse.com/thing:2609112 The doors have had the aquila removed for use with Horus Heresy / 30k but are otherwise unchanged. The double bulkhead…
This is a remix of some of the Zone Mortalis walls by Eberleg found here: https://www.thingiverse.com/thing:2609090 Not all files have been fixed, only the ones I needed. The only adjustment made is that I have made them solid. This…
This is a remix of Whitys ( https://www.prusaprinters.org/prints/58412-ikea-alex-handle ) remix of TimCCs ( https://www.thingiverse.com/thing:2939638 ) drawer handle for IKEA Alex. I preferred Whitys version without the label so I used…
This is a very simple remix of Kilcrops updates ( https://www.thingiverse.com/thing:4764317 ) to igalopakas design ( https://www.thingiverse.com/thing:4614384 ). The only change is that it is updated to the later revision Clockwork…
Update 2021-06-25: Added alternate bases. This is remix of https://www.thingiverse.com/thing:4631883 by tomasotwo. These are 3D banners that replace the cardboard tokens included in the board game War of the Ring. I have split the…
This is a very simple remix of the rear piece of Haydn Baos ITX NAS case called MASS. The place for a PSU has been removed and replaced with a solid backing plate and holes for an external PSU and power button. The hole for the button is…
This is a very simple remix of the front piece of Haydn Baos ITX NAS case called MASS. It removes the 2.5" drive bays to increase space inside the case and decrease print time. It also changes the positions of the zip tie anchors to a…
This is an addon for Haydn Baos ITX NAS case called MASS. This part can be used to mount a 3,5" HDD and a small SSD in the PSU compartment if used with an external PSU instead. It mounts by using longer screws in three of the motherboard…
This is a simple remix of the chainlink model from https://www.thingiverse.com/thing:2110834 All I did was slice off half the height of the fence and pillar in Meshmixer. This way it looks nicer I think and takes a lot less time to print.…
I wanted some way to contain all the Time Stories expansions in the main box, but unfortunately all other solutions I found used about a metric ton of plastic and could often not accommodate all ten missions in the white cycle. This…
This is a recreation and remix based heavily on Spookniks tool holder for Knipex crimping pliers for IKEA Skådis (or Skadis for those not writing with the diacritic ring). The original only had room for one tool and it felt a bit sloppy…
This is a simple remix of Dialup_Handshakes mount for Engineer PA-09 and PA-20 on IKEA Skådis (or Skadis for those that don't use the diacritic ring) to make it fit wire strippers PA-07 and PA-14. I wanted to keep the original dimensions…
These are all currently available results.
