Counting matching models…
I used 4 m3x30 and 2 m3x20 socket head bolts and nuts. I printed it with carbon fiber petg with 60% infill but I recommend the highest infill youre comfortable with. The grips are pla and 20 to 30% infill is fine for them.
Printed in PETG. To remove the original blade I used a small flathead to pry the metal ring on the shaft until it breaks off (the small metal retaining ring). I then used pliers to pull it from the shaft. The fan blade should slide off…
print 2 and use m3*12 bolts to secure
A stand for the Roland sp404 mk2. I put some carpet on the top to maybe prevent scratches and some thin foam on the bottom to stop it from sliding around.
I recommend 3 perimeters and at least 25% infill. I used pla+ but you could probably use any filament. There is a small overhang so be mindful of that It requires a 1in long ¼-20 bolt with the head cut off or a 3/4in long ¼-20 stud. It…
I printed at 100% infill in carbon fiber petg. I recommend you use a material that can withstand high temps if you live somewhere it gets hot. Its a pretty simple design with no overhangs so it should print pretty well with no fancy…
I used petg at 31% infill. You could probably use whatever filament you want.
It fits on wire shelves with 5mm wire on the edges. I used petg.
I used carbon fiber petg and 4 perimeters at 50% infill, but you can use any outdoor safe filament you want (it will be holding very little weight). it is a permanent mod so maybe sleep on it before committing.
These are all currently available results.
