Counting matching models…
I made this MFT tray to hold my clamps, a mix of Festool and microjig ones, store my UJK dogs, and to put a few marking tools. The tray can be printed without supports and I used build plate supports for the nut. I used four M4x14 machine…
Each stack can contain 14 Cricut pens. I used PLA in 0.3 draft mode with my MK3S.
The supports are compatible with 42mm gridfinity grid. The one with tools is made to accomodate the Proxxon collets holder. The holes should fit 2.4 mm (3/32") and 3 mm (1/8") bits. I usually print those in PET or PLA with brim to ensure…
This jig is compatible with Blum 561 slides commonly found in Ikea bathroom cabinets. To use the jig, you will need to make a drawers based on the slides you have. You can find design notes here:…
This tool holder prints without support. I used 0.3 mm PLA settings. This holds the Incra router lift hex key, the hex to tweak the Incra fence settings, and a small hex to extract plates from the lift. The holes are made to accomodate 4…
This is the 3d version of the holders I made out of scrap wood. I made 2, one for the regular set of plates and one for the cleansweep version. Holes are made to accomodate 4mm wood screws or equivalent.
Prints without support on the side. I used 0.3 mm PLA settings and reduced the model height by 2 to test strength and it holds perfectly well. The holes are made for 4 mm wood screws or equivalent.
Based on the model here: https://grabcad.com/library/guide-store-occultant-bas-velux-dkl-s-1 I need a part that support the duo version with two blinds instead of one. You can mirror the part to get the other side. I recommend using PETG…
These are all currently available results.
