Counting matching models…
Here are a couple of tips for an E6000, 3.7 oz tube of adhesive. Fine has a 1.5mm tip, Small is 1.8mm, Medium is 2.0mm and Wide is about 4.3mm. No supports, raft, or brims 2.0mm PLA 15% infill Rotate the part 90 degrees, then use the…
TPU boot that fits over the threads of an REI “Trailbreak” trekking pole. Should fit all REI poles and likely many others, but who knows? One boot prints in about 1.5 hours. Make a few extras for your next trek so when the boot gets bored…
This is a holder and waste basket for the Filament Cutter https://www.prusaprinters.org/prints/67509-filament-cutter-45deg designed by Pomi. I loved the idea of a filament cutter bracket on the printer that would keep it from getting…
Not sure if it was just the cleaners I was using on my counter, but the feet of my sealer would smear rubber wherever it was used. Hello, 3d printer. This is a set of replacement feet for just about any Impulse Sealer on the market. It…
These are all currently available results.
