Counting matching models…
This is an accurate recreation of the Prusa MK3 POM TR8x8 and probably other printers (other ones I tried from thingiverse didn't match the lead pitch). I print them in PLA and use them in a MK2 clone I have lying around, they work…
This is a replacement for a broken one. Slightly different but does the job. Has built-in supports.
This is a case for holding a NodeMCU v3 and 4x 7-segment MAX7219 8x8 led matrix. NOTE : The holes for the NodeMCU board are not properly aligned. The board fits but screws are a little angled. Will fix soon. Category: Electronics
Mobula6 / Meteor65 compatible frame. Print in PLA, PETG might work but found mine to flex too much. Print slow, will make it stronger. After printing break the supports under the ducts and FC mounts. You might need to re-drill holes on…
prints without supports in about an hour, face it backwards to your blower fan. charging port snaps into.
A convenient stick holder that makes it fast to grab and put back. Use 1mm EVA foam between parts.
Simple cover for the JR module bay. Customize at your own. Category: R/C Vehicles
A shim to "soft" lock the rear differential without damaging original parts. Print two of them. Category: R/C Vehicles
Dock designed for Xiaomi Mi A2 and stock USB-C cable but should fit others phones. Print on the side. No supports required. Once printed break the support on the hole for the cable adapter. Warning the STL for the cable should rest flat…
This is a big ass knob that perfectly fits the Prusa MK3 LCD cover. I designed this one because the other ones I found are too tall or short or simply weird. Category: 3D Printer Parts
The case is tight, adjust your printer accordingly. Tip : use no top/bottom layers and hex infill for a faster and cooler print. Print the gasket in TPU or cut it from EVA foam. For the quietest setup, layer in this order, discarding the…
Same dimensions as the one on the mobula6 Category: R/C Vehicles
No need for TPU, works fine with non-flexible materials.
Sturdy, durable and lightweight (~1.3g) canopy for 25.5mm mounting. No props in view. Category: R/C Vehicles
I designed this for the Skelestruder. Requires: 2x m3 square nuts 2x m3 headless screws Recommended to print slow and at low layer height. Concentric infill, 3 perimeters. Set extruder steps/mm to 1120 with M92 E1120 then M500 to persist…
requires 2x 2.5x14mm dowel pins and 2x twisting balloons. prints flat, no supports.
not really a remix but a redesigned hard canopy for the happymodel moblite inspired by angry don's version. print in PLA flat to the build plate using supports for the optimal structural strength. only 3 screws needed. weights about…
Print in PETG, this thing gets hot and PLA will deform. There's two top cover versions, one for HappyModel and another one for "Rcharlance" branded one. Category: R/C Vehicles
This is a plug and play belted gear box with 3.5:1 gear ratio (when using a 16t pulley). I'm using it on my Bear extruder with an LDO 0.9 Slim Power stepper. Very inspired by https://www.thingiverse.com/thing:3553286 and…
Designed this because 1983mor's version does not exactly match the BMG mount. Category: 3D Printer Parts
These are all currently available results.
