Counting matching models…
This doesn't need supports, it leaves lots of room for airflow throughout the bottom, and provides 6 mounting holes for flexible options. Pick any two. The base is oversized enough that this isn't a tight fit, and the cables can exit…
Minimum height for a 15mm shaft EC11 encoder, small enough to fit in choc-spaced keybaords. Conceals layer lines with shape. No support necessary. Built in OnShape
These print best on resin printers, and they are very thin. Maybe too thin… I'd recommend ‘abs-like’ for less brittleness. I've tried printing on my Creality CR10 S Pro V2 with a Hemera direct drive extruder and volcano hot end. Not good.
Made a holder for the sideclick's original mounting points. It's intended to have some adhesive foam inside the cradle, but the sideclick attachment seems as good as factory. I designed it to be oriented almost vertically, so there are…
This snaps onto the Go, and provides a standard tripod mount (via ¼"-20 nut inside) for stabilizing long exposures with a camera not meant for long exposures.
These are designed to click onto the factory SideClick mounting tabs, and fit snugly onto the Roku Voice remotes. They are designed to print with no supports, with the flat on the bottom of the remote flat to the bed. Simple, strong,…
I cut down an IKEA IDANÄS shelf and wanted a jig to center the dowel holes I needed to drill into the cut ends.
I needed an offset mount to set my Sony a6500 back on the top of the Vivo monitor tube, so the monitors could angle inward closer. It's designed to be printed as it come into your slicer, with the recesses facing upward. No supports are…
These are all currently available results.
