Counting matching models…
Update 3.3.2026 Added a slight angle on every second output slit to create a wider, cone shaped showerprofile. Added two more brimtabs and did some minor fixes on the model.. I also took 0.15mm off the impeller width as it was…
Update 6.3.2026 I've noticed the cavity in this gets filled with water after a while, I'm gonna try to fix it in the model, in the mean time, set a layer range from around 15.45 - 17 with 100% infill... or drill a whole in the outer…
Update 22.3.2026: New improved version with a bit retaining mechanism, Also made the handle ~20mm longer + some other tip shapes ============================= Pry tool for removing objects from printbed, no need to get in there with your…
Makes it possible to adjust the distance between the Z screws and Rods, so that the screws and rods remain perfectly parallel throughout Z travel. It also decreases wear on the screws and trapezoid nut in case the distance between the Z…
Tool for measuring the distance between Z rod and Z screw I added an ironing modifier but I couldn't make it work well, the direction of the ironing would need to be the same for each layer. You'll want to print it with pla and on the…
Use by setting the following custom settings on the tabs and then placing them near what you want to hold to the build plate: Elephants foot compensation = 0 Brim Separation Gap = 0 Brim Type = outer only Brim Width = 0.5 or similar, if…
I updated this with slightly thicker walls, and beefed up the bottom wall. It was quite weak do to the holes and thin bottom. Print the case in PET-G for toughness. The stand folds with plastic hinges, so they last for a while but not…
These are all currently available results.
