Counting matching models…
These cases are compatible with the following Feather boards: Adafruit Feather HUZZAH with ESP8266 WiFi: https://www.adafruit.com/product/2821 Adafruit HUZZAH32 – ESP32 Feather Board: https://www.adafruit.com/product/3405 Feather ESP8266…
Note: Vase mode with a brim is required. This also hollows out the top so that a label can be slipped in. A customizable clone of the plastic trays provided with MD's Halo True/Clear switches. The trays keep the switches nicely organized.…
v2 update : The v2 puller has been made thicker, the brim at the ends have been removed and the grabber progressively slopes upward to begin lifting the target board out as the prongs are squeezed. --- Normally my fingers get squished…
This is a stand for a generic 12v peristaltic pump (available from many vendors). The particular peristaltic pump used and fitted to this case is this one . Bill of Materials/Required Hardware: 2x M2.5x16 Socket Cap Screw (source:…
This is a printable drawer divider for the small drawers on the Akro-Mils 10164 Storage Cabinet.
Features Optional compartment for a 350mAh LiPoly battery (with a zip-tie strain relief slot) Slot for a rare earth badge magnet (source provided) Support for Adafruit's stackable Feather wings Cable management and routing slots Upside…
A magnetic/suction cup mount for 1/2 (half-sized) breadboards. For whiteboards and strange places. These attachment methods were tested with this print: Adams Manufacturing 7000-75-3040 Mini Suction Cup Hook, 3/4-Inch - (The trick to…
A modified cover for the Odroid XU4Q (fanless) that fits the " Odroid XU4 Gehaeuse / Case " by CBiker Print instructions Resolution: 0.2mm Infill: 20% Notes: Materials: Red: Atomic Filament Dark Cherry Red PLA 1.75mm Gray: Atomic Filament…
A simple one piece sleeve case for the Particle Debugger . To use, insert the board USB connector first (orient so headers are exposed). Follow the guides on the sides until fully inserted, then press down on the ends of the board to…
A simple one piece sleeve case for the Particle Debugger . To use, insert the board USB connector first (orient so headers are exposed). Follow the guides on the sides until fully inserted, then press down on the ends of the board to…
This is a soldering smoke absorber with a cartridge system. If you build and use this, please don't do it in a closed environment. A decent absorber needs a HEPA cartridge too! This doesn't have one (yet). More detail about this print and…
This is a remix of the Particle Mesh Feather Case that supports Adafruit's 400mAH battery in a form factor ideal for Feather boards. You can pick up a battery here . In this version, the magnet is only supported on the case's top/lid.
Here's a case that works with the Feather-compatible Argon and Xenon (Boron compatibility hasn't been tested). Argon: There is a cutout in the back of the case for the Argon's Wifi antenna (fish it through and connect before enclosing).…
Print Settings Printer: Prusa i3 MK2 Rafts: Doesn't Matter Supports: No Resolution: 0.15-0.2 Infill: 20% Notes: Filament: Plasty Mladec ( http://www.plastymladec.cz/ ) Yellow PLA
This is a simple case for Boldport's Cordwood Puzzle Too. Be sure to align the cover's tabs with the base's tabs! This also has a secondary use, as a box that this funnel fits into . Cordwood puzzle too @ Boldport
These are all currently available results.
