Counting matching models…
I made this model looking at what others have made but adjusting to my needs, (didnt remix any other model in this, made all from scratch). I needed a strong and secure casing for my ESP32Cam with USB module, that would acomodate the…
This is a Remix of : “Pliers holder” by SDHayes I just made the big holes that hold pliers a little bit bigger, now they are 17.5mm so they can hold the pliers that I use, hopefully they can hold yours too.
This is a Knob for an Angle Stop Valve that is used most frequently on toilets. Print with supports is best so it doesnt hang, however might not be necessary. 4.0 nuzzle .2 layer height 6 wall thickness since it can excert a lot of force…
I made this so the button is not rambling arround the house and people know where to put it (if they take it out). I didn't want to glue the button directly to the wall, because it kinda reduces it's wireless functionality, hence this…
I created this print because I was tired of buying button batteries. Don't get me wrong they can last up to a year, but sometimes they are not of the best quality and they last for a couple of months, and you have to get new ones, and…
I printed the Creality Ender 3 Sunlu Dryer Mount Bracket then I printed the spool holder and guess what, you cannot mount it under the Sunlu dryer because it wont fit, the spool arm holder is short. So I made the spool holder 48.5mm so…
Replacement part for the discs these toys throw
This holder uses 2 anchor points in the HSW so it wont bend due to its own weight. I printed vertically, the only support i needed was for the top anchor point. otrherwise everything should print without supports If you dont want to add…
I design this to avoid clutter on my desk so the Odroid M1 could be mounted on the wall. You should use supports only qhere the connectors are located, everything elese should print just fine. I recomend using PETG or ASA or other…
This pin or tab, is for the Koblenz WD-5K 5 gallon Vacuum, it might work on other WD models, but I haven't tested. Printed in PLA, this model needs to be printed on its side, so make sure you generate supports and if needed use brim so it…
Created this for the Ender3 v2 Z-axis mount, it is better secured in place and also you can use a nut to screw to the eccess of the screw that holds the axis. No need to unscrew anything. just screw on top of it. Its better suited if you…
These are all currently available results.
