Counting matching models…
A simple 120 film spool I designed because my camera didn't come with one. Also handy if you're trying to make your own film or need something to wrap your spaghetti onto. Comes with your choice of either cross shaped or slot shaped drive…
A simple ¼" tape reel, available in 5 inch, 5.75 inch and 7 inch sizes. Modeled mostly according to NAB Reel Tape Standard 1965 except for the flange spacing which is the much more common modern 8mm spacing. Prints in two parts without…
A set of magnetically attached way covers for both the lathe bed and cross slide. The bed covers are meant to hold 100mm flat bellows which can be found on ebay for pretty cheap. They consist of one bottom piece that attaches to the bed…
Replacement battery door for a KORG Monotribe in case you're missing yours. I'd recommend to print it from something like a not too brittle PLA plus or PETG so the latch flexure doesn't immediately snap off. FreeCAD source file included.…
This is the enclosure and microphone clip for the Æthervox electromagnetic field microphone which can be found here: https://git.sr.ht/~slyka/aethervox The main body of the enclosure should be printed laying down with the switch/graphics…
Replacement rubber foot for a KORG Monotribe in case you end up with a footless one like me. Print from some kind of soft TPU, I used ColorFabb VarioShore TPU. Attaches by just jamming it into the screw hole but you can also add a little…
These are all currently available results.
