Counting matching models…
I extended the height of the Ender 3 slim fan duct so that it would work on my Ender 2 Pro. This is still a work in progress and the print isnt super clean. I had to extend it by about 6-7mm as the two sides clip inside the part cooling…
The clip that holds my trunk cover snapped off. I modelled one which can snap in-place. You can also remove the tabs and glue it in-place. I'd recommend a heat stable plastic like PETG, Nylon, or ABS. Nylon might be too flexible. 100%…
KlackEnderPro2 A modified version of the KlackEnder project to work with an Ender Pro 2. Its a remix from daaar on Thingiverse.com There weren't step files included so I had to modify some of the models creatively. Tolerances are between…
I remixed this model so that larger tools can fit through the handle holes to screw it down. I also made it longer to be more ergonomic. I also flattened the bottom to help improve printing. I usually print with a 0.4 mm nozzle at 0.16mm…
Modified the arm to be longer. Will crash into the screen if in use. Moved to Klipper so don't need the screen anymore. Because I added a second cooling fan I could not see my prints anymore. Also modified the camera holder to support the…
This is a coupler design I prefer over the brass fitting which is meant to bite into the PTFE tubing. Ive found it very hard to get the correct torque such that the tubing isnt squished but that its is solidly connected to the extruder…
This is an adaptor for my step drill to allow it to fit in my chuck which can only take up to 10 mm drills. I would print with 100% infill and 0.2mm on a 0.4 mm nozzle, then cleanup the edges. Makes use of two M3x5mm bolts Im unsure how…
The original back cover of this hairdryer likes to suck in hair. I made a new one to stop this. This is my first OpenSCAD model I printed it at 0.2mm with traditional grid supports. The supports were a bit difficult to remove.
This is a super simple adaptor to allow you to attach a 8mm Pulley Bore to a 5mm Motor Shaft. I did this so that I could attach a dampener to the y-axis (bed) of my Ender 2 Pro and adjust the pulley to correctly align the belt. This was…
These are all currently available results.
