Counting matching models…
Simple wall mounts for mounting with countersunk M4 screws. Base plate is connected to wall mount using M3x12 mm (may be longer) into M3x4x3 inserts. Two variants are provided: Wall mounts with only one insert for the left and right end,…
A simple remix with a groove for inserting an M3 screw - long enough to leave “wiggle room” if your measurement of the wall mounts' distance was not spot on. Two variants: A 6x2 and a shortened 4x2 version. Prints without supports.…
A holder for screwdrivers in Gridfinity boxes. Flat for easy storage, holes on lower holder so the screwdrivers don't fall out if you tilt the box up. Easy removal - just tip on the bottom of the screwdriver; the hole is angled so the…
Rolling grinder a la Horl. Holder has angles for 15 and 20 degrees (afaik 15 is recommended for higher-quality knifes, 20 for softer steel). I bought discs with 400 and 1000 grit (one for getting the basig angle, the other for actual…
A place for my Unifi PoE injectors using the excellent ESRack system by @EvilProphet . (height: 1 Rack unit) There already are other Unifi holders for ESRack - but since I have a mix of models (and each of the dozen or so PoE injectors by…
Inspired by this awesome idea - unfortunately I own a different model of calipers. Installation requires disassembly. Remove back cover (some heat helps) and unscrew the four screws: The front can now be lifted off. Close to the battery…
Get your Beatstep to the height and at the angle you like! :-) Height and angle are parameters in the FreeCAD's spreadsheet section. Contains openings for gluing in rubber feet to avoid sliding on the desk. Provided STL file will raise by…
“Draussenfuchs” ist eine Funk-Fuchsjagd auf dem freien 430 MHz-Band (und somit nicht nur für lizensierte Amateurfunker ein Spaß). Die Webseite hat Anleitungen für alle nötigen Komponenten, unter anderem auch eine Yagi-Richtantenne (die…
This is a remix of the runner part of the excellent "Table Saw Blade Alignemnt Jig". The original runner has a rectangular profile which does not mach the T profile of the Bosch tablesaws. I made a quick remix which fits quite nicely. To…
I had to attach the socket to a concrete wall. The so-called wall mount of the Brennenstuhl socket is just a small hole, allowing zero tolerance. So I screwed in the top screw and created this bracket for the other end. Use M4 screws.
A place for my Fritz!Box using the excellent ESRack system by @EvilProphet . It's a huge print, it barely fits on the bed of my Sovol SV08… but the width of the Fritz!Box is larger than a 50% module, so I went this route. If you try using…
When I first saw the Solarpunk Synthesizer kit , it was clear that I just had to have one ;-) I created an enclosure which, ahem, encloses all parts for storing, and can also act as stand for the solar panel. The lid contains spacers so…
These are all currently available results.
