Counting matching models…
a gridfinity magnet base for the pinecil and ts100 soldering iron, has a compartment for brass sponge to replace the giant spring soldering iron holders. designed so the tip does not extend past the back side of the base so it can still…
a pair of collet set gridfinity storage for imperial and metric ER32 collets, with labels. made as large as possible to fit on the Mk3 print bed. standard 42mm gridfinity plate with magnets. both have the ‘common’ collets i use most…
Has change gear slots for: 80 tooth - x2 60 tooth - x2 50 tooth - x2 45 tooth 40 tooth 35 tooth 30 tooth optional magnet holes in each gear slot as well for extra security
3-jaw chuck holders for inside, outside and blank jaws along with matching screws
for actual 1"x2"x3" blocks, not the slightly smaller metric versions
gridfinity with magnet holes, holder for MT3 dead center
Gridfinity with magnets, MT2 dead center holder LARGE style
MT2 lathe live center holder for gridfinity with magnets
Gridfinity with magnets, 4-jaw lathe chuck with studs holder and place for chuck key
gridfinity with magnets, holder for 10mm lathe chuck with studs, and chuck key.
Gridfinity with magnets, holder for small size MT2 dead center
just a simple plate mount that can be glued in between the bottom frame rails of the guitar body. i use and recommend a USB-C variant of the pro-micro because the tight space for the cable to plug in and out of the body can be a bit rough…
Gridfinity with magnets, lathe chuck holder for ER32 chuck, and two standard sized collet nuts
this is a simple mini gauge for quickly adjusting the stickout for tungsten based on the cup size you are using. there is also space on the backside for 6x - 6x4mm magnets. (or 2 more common 6x2mm magnets per hole) the lettering sticks up…
Gridfinity with magnets, holder for jacobs chuck JT33, with chuck key
this simplified latch design uses the same screws and distances etc of the original model, it just latches directly to the bottom screw on the case body instead of using a finicky cam latch style. there is no need to change anything from…
These Welding table V-blocks are meant to be used with 16mm (5/8") holes. Designed in two parts so they can be printed with the proper strength orientations and also printed easily and then glued together. simply use superglue or whatever…
this model changes the mounting hole spacing for the USB-C extension cable. specifically to accommodate the adafruit panel-mount USB-C extension . the screw holes for this extension are further apart than the original model
These are all currently available results.
