Counting matching models…
Basic Z-Offset test that can VERY QUICKLY show problems with z-offset, z-retraction, xy tolerances, and flow rates. Takes about 1 min to print on a 0.6mm nozzle and uses 0.61g of filament. This is great for fine tuning and walking in…
Keystone geometry based on domrim's design. This is intended to be used in your designs, not standalone. You should be able to merge this STEP file into your designs and have a fully functional, tight lockup, and properly reenforced…
This is designed specifically for the Primary Arms 1-6x LPVO scope. It fits snugly between the front objective and the factory lens cover. Simply remove the cover assemble, jam this in, and replace the lens cover. This is friction fit so…
This is a remix for the well-fitting mount made by Kavelry3D for the Milwaukee M12 drill/impact/hammer drill mount to mount under a shelf. Mounting surface is at 45 degrees which requires it to be mounted pretty near the edge of a shelf…
This is a replacement mount for the solar radiation shield for the La Crosse weather station remote sensor probe enclosure model 925-1418. These units are the ultimate torture test for filament so at a minimum use PETG. ASA or ABS would…
These are all currently available results.
